Key Features & Benefits – EPMAN weld-on aluminum fuel filler neck, silver, 1.5" (38mm)
The EPMAN weld-on aluminum fuel filler neck, silver, 1.5" (38mm) is designed to be welded into a tank wall for custom fuel tanks, water tanks, coolant reservoirs, and other fabricated metal tanks. The weld-on layout helps you place the fill point where your routing and packaging require it.
The body is 6061-T6 aluminum, sealed by a screw cap with a rubber sealing ring. The cap has a knurled outer edge for grip, and the unit is a non-vented design.
When is this useful?
It suits builds where you want a compact weld-in fill point and need the 38 mm neck OD to match your hose or tube routing while keeping cap access predictable.
Technical specs
- Material: 6061-T6 aluminum
- Design: weld-on fuel filler neck, screw cap, rubber sealing ring
- Type: non-vented
- Color: silver cap
- Neck OD: 38 mm (1.5")
- Neck ID: 24.5 mm
- Length including cap: 32 mm
Selection & installation tips
- Hose/tube match: Match the 38 mm neck OD to your hose/tube and clamp choice.
- Flow check: Compare the 24.5 mm neck ID to your filler tube and tank opening to avoid an unwanted restriction.
- Packaging: Confirm clearance for the 32 mm length including cap so the cap stays accessible.
- Venting plan: Because it is non-vented, plan tank venting separately within your system design.
- Weld fit-up: Clean the weld area and test-fit orientation so routing does not preload the joint after welding.
Before welding, verify your hose/tube sizing, cap clearance, and venting strategy, then compare them to the listed OD/ID and the length-including-cap dimension.
