Key Features & Benefits – TurboWorks silicone 45 degree elbow hose 60 mm black
The TurboWorks silicone 45 degree elbow hose 60 mm black is a reinforced silicone elbow hose for intake systems, cooling systems, and intercooler pipework. For functional compatibility, it matches 60 mm inner diameter connections, and the 45° bend helps route piping cleanly in tight engine bay layouts.
Built as 4-ply reinforced silicone, it is specified for -50°C to +260°C operation and tested up to 7 bar pressure. The material is resistant to oil vapors, grease, and coolant for long-term use in typical under-hood conditions.
When is this useful?
This is useful when you need a 45° direction change in a 60 mm pipe run on the intake or intercooler side, or within a cooling circuit, while keeping a flexible connector designed for heat and pressure exposure.
Technical specs
- Inner diameter: 60 mm
- Length: 100 mm
- Bend angle: 45°
- Material: 4-ply reinforced silicone
- Tested pressure: up to 7 bar
- Temperature range: -50°C to +260°C
- Color: black
- Resistance: oil vapors, grease, coolant
- Typical application: intake system, cooling system, intercooler
Selection & installation tips
- Confirm sizing: measure your mating pipe outer diameter and ensure the 60 mm inner diameter gives the correct fit.
- Check clamp land: allow enough straight pipe on both ends of the 100 mm hose for secure clamping.
- Validate the bend: align the 45° angle to your routing and avoid twisting the elbow during installation.
- Prep the joint: install on clean, burr-free pipe ends and position clamps for even compression behind the edge.
- Heat & abrasion: keep clearance from hot components and make sure the hose cannot rub against nearby parts under load.
Before installation, self-check the 60 mm inner diameter, the 45° bend, and the 100 mm length against your pipework, and verify you have clean seating surfaces and enough room for proper clamping.
