Key Features & Benefits – AN10 dual hose separator 20mm aluminum black
The AN10 dual hose separator 20mm aluminum black is designed to secure two hoses or cables in a tidy, stable layout. It is intended for AN10-sized hose/line setups where a 20 mm clamp size matches your routing point.
Made from CNC-machined aluminum with a black anodized finish for corrosion resistance. The dual design helps keep lines organized and away from moving engine parts, supporting cleaner routing for braided high-pressure rubber hose, rubber hose, and PTFE hose.
When is this useful?
This is useful when you want two parallel lines held in place at a mounting point to reduce chafing and movement from vibration in the engine bay.
Technical specs
- Size: 20 mm
- Type: dual hose separator
- Material: CNC-machined aluminum
- Finish: black anodized
- Use-case: braided high-pressure rubber hose, rubber hose, PTFE hose securing
- Category compatibility: AN10 size hoses and lines
Selection & installation tips
- Confirm line size: measure the hose outside diameter at the clamp point and match it to the 20 mm clamp size.
- AN10 check: with AN10 braided or PTFE lines, verify the actual outside diameter as it can vary by hose construction.
- Mounting point: choose a rigid, vibration-resistant mounting spot and position it so lines cannot contact moving parts.
- Routing protection: allow for engine movement and avoid hot zones to reduce softening and abrasion on the hose.
- Seating & stability: ensure both lines sit without stress and the clamp does not distort the routing path.
Before installation, verify the 20 mm clamp size and AN10 system match, the rigidity of your mounting point, and free clearance along the routing, then compare your setup to the technical specs listed above.
