Key Features & Benefits – 2-hole exhaust hanger rubber insulator, 40 mm hole spacing, 11.5 mm holes (black) – EPMAN
The 2-hole exhaust hanger rubber insulator, 40 mm hole spacing, 11.5 mm holes (black) – EPMAN supports the exhaust at hanger points and helps reduce vibration and rattles caused by exhaust movement.
It can be used as a replacement for worn or stretched hangers, helping limit exhaust sag and excessive movement during acceleration.
When is this useful?
Useful when the exhaust sits low, knocks against the chassis, or the original hanger is cracked or softened and you want a more controlled hanger setup.
Technical specs
- Design: 2-hole exhaust hanger insulator
- Material: rubber
- Overall size: 2.87" × 1.85" × 0.83" (73 × 47 × 21 mm)
- Hole diameter: 0.45" (11.5 mm)
- Hole spacing: 1.57" (40 mm)
- Package: 1 pc
- Color: black (also available in blue and red)
- Application: universal (size-based)
Selection & installation tips
- Measure your hanger rod diameter and confirm it matches the 0.45" (11.5 mm) holes.
- Confirm the bracket/rod layout matches the 1.57" (40 mm) hole spacing.
- Check surrounding clearance (heat shields, braces, body) against the 73 × 47 × 21 mm overall dimensions.
- Install without twisting the rubber, and avoid preloading the exhaust to one side.
- After installation, verify there is no contact at idle and during quick throttle blips, and that safe movement range remains.
Before purchase, verify your exhaust mounting points, hanger rod diameter and hole spacing, then compare them to the listed technical details.
