Key Features & Benefits – EPMAN Titanium exhaust heat wrap (2" / 50.8 mm x 10 m) with stainless ties
EPMAN Titanium exhaust heat wrap (2" / 50.8 mm x 10 m) with stainless ties is intended for wrapping exhaust manifolds/headers, turbo hot-side sections and exhaust pipes to help reduce radiant heat around nearby components.
With consistent overlap and tight wrapping, it can support cleaner heat management in tight engine bays, while the included stainless ties help keep the wrap secured at the start/end points and along longer runs.
When is this useful?
It is useful when your exhaust manifold or piping runs close to wiring, hoses, or other heat-sensitive parts and you want a practical way to keep heat better contained around the hot surfaces.
Technical specs
- Material: titanium fibre wrap
- Size: 2" (50.8 mm) width x 10 m length
- Temperature resistance: up to 2000°F (approx. 1093°C)
- Included fasteners: 4 stainless steel zip ties
- Zip tie size: 5 mm wide x 300 mm long
Selection & installation tips
- Measure the total section length and pipe outside diameter first, then allow for overlap so 10 m covers your planned run.
- Keep tension and overlap consistent to avoid gaps between wraps and to minimize loosening after heat cycles.
- Secure both ends; use additional ties on longer sections or where vibration could work the wrap loose.
- Avoid contact with moving parts and sharp edges that can chafe through the wrap over time.
- After the first heat cycle, re-check tie tightness and wrap position.
Before fitting, confirm your pipe outside diameter and the length you want to cover, then compare it to the 2" (50.8 mm) width and 10 m roll length while factoring in your intended overlap.
