Key Features & Benefits – EWP mounting bracket kit with rubber damper
The EWP mounting bracket kit with rubber damper is designed for mounting Davies Craig EWP® electric water pumps in the engine bay and fits EWP®115, EWP®130, EWP®140 and EWP®150 models in Nylon and Alloy versions. It provides a defined mounting point when the pump is not intended to be supported only by the lower radiator hose.
A rubber damper is included to reduce vibration transfer into the mounting point, helping minimise vibration-related stress. The bracket adds flexibility for clean hose routing and a stable pump position within your engine-bay layout.
When is this useful?
When you want a more rigid, tidy pump mounting location while still isolating vibration through a damper, this accessory supports a stable engine-bay installation.
Technical specs
- Compatibility: EWP®115, EWP®130, EWP®140, EWP®150 (Nylon and Alloy)
- Function: hard mounting support with vibration isolation via rubber damper
- Kit contents: Rubber Damper (1), Steel Ring (1), Nut Nyloc 3/16 (1), Bolt Hex 1 3/4 x 3/16 (1)
Selection & installation tips
- Model check: confirm your pump model is EWP®115, EWP®130, EWP®140 or EWP®150, and identify Nylon vs Alloy version.
- Mounting point: choose a rigid, flat engine-bay location that keeps hoses free from tension.
- Isolation setup: install the rubber damper so load is transferred through the isolator rather than metal-to-metal.
- Clearance: verify bolt/nut clearance so the bracket hardware does not contact nearby components.
- Hose routing: after mounting, re-check hose arcs and ensure hoses do not rub on sharp edges.
Before installation, verify pump model compatibility, mounting location and clearances, then match your setup to the compatibility list and kit contents above.
