Key Features & Benefits – M14 x 1.5 to AN6 banjo bolt
The M14 x 1.5 to AN6 banjo bolt is used in turbo water-cooling plumbing when you need to convert an M14x1.5 banjo connection to an AN6 line. The stainless steel material suits durable installation in engine-bay conditions.
As a functional compatibility anchor, it is used around GT25 GT28 GT30 and MHI TD05 TD06 turbo water-line connections when the port is M14x1.5 and the system is built with AN6 hose/fittings. Sealing and banjo eye dimensions must match the full assembly.
When is this useful?
It is useful when you want to route turbo water lines in an AN6 system and the turbo-side connection requires an M14 x 1.5 banjo bolt, keeping the plumbing consistent with the rest of the build.
Technical specs
- Type: Banjo bolt
- Thread: M14 x 1.5
- Outlet: AN6
- Material: Stainless steel
- Use: Turbo water-cooling connection
- Compatibility: GT25; GT28; GT30; MHI TD05; MHI TD06
- Part number: EP-CGQ119
Selection & installation tips
- Thread check: Confirm the receiving port is M14 x 1.5 and the available thread engagement is sufficient for a secure seat.
- AN6 match: Verify your hose and fittings are truly AN6 and the connection geometry matches your setup.
- Sealing: Use suitable sealing washers on both sides of the banjo eye and check the sealing faces for damage.
- Clearance & orientation: Trial-fit the banjo eye angle and line routing so it does not contact housings, heat shields, or nearby hardware.
- Leak check: After assembly, check the joint under pressure/operating conditions for any seepage.
Before installation, verify thread, sealing washer type, banjo eye size, and AN6 connection fit, then match them to the technical specs above for a reliable install.
