Key Features & Benefits – ARP Lada flywheel bolt kit
ARP Lada flywheel bolt kit is designed to replace factory flywheel bolts when you want higher strength and longer service life at the joint. The bolts are made from ARP 8740 material and are intended to work with existing flywheels.
The set uses a 5/16” thread and 1.500” (38.1 mm) UHL length, with a 3/8” wrenching size for familiar tool access. The design targets heat and corrosion resistance, which is useful where components see higher load or frequent disassembly.
When is this useful?
During a clutch or flywheel service, the ARP Lada flywheel bolt kit helps you build a consistent, checkable fastening setup, with thread, length and wrench size that you can confirm before final assembly.
Technical specs
- Thread: 5/16”
- Length (UHL): 1.500” (38.1 mm)
- Wrenching size: 3/8”
- Material: ARP 8740
- Use: Replacement for factory Lada flywheel bolts
Selection & installation tips
- Thread match: Confirm the 5/16” thread matches your crank and flywheel threads.
- Length & engagement: Verify 1.500” (38.1 mm) UHL provides proper thread engagement and the bolt does not bottom out in the hole.
- Tool access: Make sure the 3/8” wrenching size is accessible with your installed flywheel and surrounding parts.
- Clean interfaces: Clean threads and mating faces before assembly so the joint seats evenly.
- Tightening control: Use a controlled tightening sequence and apply the torque method and value that match your specific engine and flywheel setup.
Before installation, verify thread, length, tool access and mating surface condition, then compare them to the technical specs listed above.
